ELAUSYS ANB-KNX AnB Rimex TRICOM Interface

ELAUSYS ANB-KNX is a KNX gateway for the TRICOM alarm system. It enables communication with the alarm system using the RS485 communication port from the alarm system.

- KNX Interface for AnB Rimex TriCom alarm systems
- Up to 96 configurable status in real time
- Built-in termination resistor for RS485
- Communication fault monitoring
- Galvanic insulation with the KNX bus

DESCRIPTION
The KNX interface module ANB-KNX is a KNX gateway for the AnB Rimex TRICOM alarm systems. It allows to send status from the alarm system to KNX using the RS485 bus from the alarm system.

Integrators can take advantage of a fully integrated alarm system, partition status, sensors status, automatic lighting using the motion detectors,?

This interface is intended to be used with a ANB RIMEX TRICOM series alarm system using one of the on board RS485 communication port of the alarm system.

It is possible to install 2 ANB-KNX on the same bus to be able to monitor the status of up to 192 program steps on KNX.

Program steps 1-> 96 on interface ANB-KNX 1

Program steps 97-> 192 on interface ANB-KNX 2



By configuring the program steps of the TriCom, it is therefore possible to send the status of detectors or areas (arming/disarming,?) to KNX.